Detailed Notes on h4831sc load data
Detailed Notes on h4831sc load data
Blog Article
This is certainly purported to be the "head over to" powder-or darn near to it- for almost any bottle-necked cartridge a single could handload. It truly is the inspiration for a great number of pet loads, nevertheless I haven't been pleased with the outcome.
Needless to say, the Hodgdon tech wouldn't endorse my mixing of different whole lot figures, but I feel I realize why. It is a litigation-pushed earth, and a few idiot would definitely deduce that he could combine H380 and H110 and come up with his possess custom made combination of powder. What a world.
Can they be interchanged without any concerns other then making use of normal load practices when switching from ton to ton?
Warning utilizing SC or SSC produced loads with extended Minimize, back again off and operate up. Use Safe and sound loading approaches.
In any case, I realized The 2 lbs . of H4831SC used the identical data, but I did not know no matter if there was just about anything different involving a pound of powder labeled "Extraordinary" and a person not so labeled. A contact to Hodgdon confirmed which they were in fact identical and the only real big difference was The emblem within the label.
I do know, rough moments. H4831SC will definitely perform, I just didn't like the case density when loaded prolonged. I don't bear in mind powder charge off the top of my head but I had been launching a Berger 168gr VLD at three,000fps and that is wherever I normally goal to be. With your situation using what you've (and what I should have done) I'd personally get started with the tip h4831sc load data in the bearing surface area from the bullet proper on the shoulder/neck junction, and flirt with extending seating depths from there when you find a velocity node.
You could have to generate several more posts to receive cleared to carry out PM's. When you finally get to that position I'd write-up while in the classified reloading part to find out if anyone is in your area for a trade.
Im under the understanding I choose to use h4831sc. I have go through that these powders h4831sc are identical Other than the shorter grain dimensions in the sc. Ought to I still be on the lookout for h4381sc?
I could stack em h4831sc load data in a single hole but I wasn’t satisfied with the velocity. After months, I received lucky and caught some H1000 on line and naturally paid a little excess. The incredibly following week in a gun present a guy experienced a whole situation of H1000 for $40 per 1lb. I neglect the amount, but While using the H1000 I’m now pushing a 160gr about 3200 and it’s a mild load.
locutus mentioned: I nevertheless have a fantastic stockpile of H450, the ball powder equal of 4831, which flows by way of my powder steps effortlessly.
I have had identical practical experience with H4350. For me, some ball powders is not going to shoot effectively with something apart from Fed215's. Some elements just Do not Participate in properly with other. Looks like you have selected three excellent powders, I'd personally assume a minimum of one of these to shoot.
I use fifty two grs H4831sc using a 117gr Hornady BTSP. It's precise, gentle mannered, and knocks whitetails down DRT. If it absolutely was me, I'd start at fifty two gr and function up.
Both of those contain the Similar burn amount, short Lower is available in handy if you are at max fill instead of at strain/velocity that you would like you can get far more shortcut in a very situation.
The container didn't hold the "Intense" symbol on it. A coworker and I then swapped some powder, And that i ended up with An additional pound of H4831SC, this a person Together with the "Intense" symbol on it.